🔒 100% private — runs in your browser, nothing is uploaded

Depreciation Calculator

Year-by-year depreciation schedules three ways — straight line, double declining balance and sum of the years digits.

Depreciation spreads the cost of a long-lived asset across the years it is used, and the three classic book methods differ only in timing. Straight line charges the same amount every year: a $10,000 asset with a $1,000 salvage value over 5 years depreciates by ($10,000 − $1,000) ÷ 5 = $1,800 a year. Sum of the years digits (SYD) front-loads the charge using the fraction remaining-life ÷ (1 + 2 + … + years): over 3 years that asset charges $4,500, then $3,000, then $1,500. Double declining balance (DDB) applies twice the straight-line rate to the shrinking book value instead of to the original base: over 3 years it charges about $6,666.67, then $2,222.22, then a final $111.11 that lands the book value exactly on the salvage value. In every method the total charged across the life is the same $9,000 — cost minus salvage.

YearDepreciationAccumulatedBook value (end)

Estimates only — not financial advice, and not tax advice. Tax depreciation (such as MACRS in the US) follows statutory tables and conventions that differ from these book methods; check your jurisdiction’s rules before filing. Everything is calculated in your browser; your figures stay on your device and are never uploaded, stored or put into a link.

Quick answers

How do I calculate straight-line depreciation?

(Cost − salvage value) ÷ useful life, charged evenly each year. A $10,000 asset with $1,000 salvage over 5 years depreciates by $1,800 a year and ends at a $1,000 book value.

Accelerated methods (double declining balance, sum of the years digits) charge the same total but earlier. Pick the method that matches how the asset actually loses value.

Why do accelerated methods charge the same total?

Because the depreciable base never changes: cost minus salvage. Straight line slices it evenly; SYD and DDB slice it front-heavy. A $9,000 base is $9,000 under all three methods — only the year-by-year pattern differs.

That is also the quickest sanity check on any schedule: the accumulated column must end at cost minus salvage, and the book value at salvage.

How to use

  1. Enter what the asset cost, what it will be worth at the end (salvage value), and its useful life in years.
  2. Pick a method: straight line for an even charge, double declining balance or sum of the years digits for front-loaded charges.
  3. Read the schedule table: each year’s depreciation, the accumulated total, and the closing book value.
  4. Compare methods by switching the dropdown — the total depreciation is always cost minus salvage; only the timing changes.

About this tool

Two boundaries are worth knowing before you use a schedule for anything real. First, these are book (accounting) methods; tax depreciation is a separate system — the US uses MACRS with prescribed lives and conventions, other countries have their own capital-allowance regimes — and a tax figure taken from a book schedule will usually be wrong. Second, the declining-balance method needs a floor: left alone it would push the book value below the salvage value (and with a zero salvage value it would never quite reach zero), so this calculator caps each year at the salvage floor and makes the final year land exactly on salvage, which is the standard textbook treatment. Estimates only — not financial or tax advice.

Frequently asked questions

What is the difference between the three methods?

Timing only. Straight line charges equally each year; SYD and double declining balance charge more early and less late, matching assets that lose value or productivity fastest when new. Over the whole life all three charge exactly cost minus salvage value — for a $10,000 asset with $1,000 salvage, $9,000 in total.

How does double declining balance work?

Take the straight-line rate (1 ÷ years), double it, and apply it to the book value at the start of each year — not to the original cost. Over 3 years the rate is 66.67%: $10,000 → $6,666.67 depreciation in year 1. The charge is capped so book value never falls below salvage, and the final year lands exactly on salvage.

What is the sum of the years digits formula?

For a life of n years, add 1 + 2 + … + n (for 3 years, 6). Each year charges (cost − salvage) × (remaining life ÷ that sum): year 1 of 3 charges 3/6 of the depreciable base, year 2 charges 2/6, year 3 charges 1/6. On a $9,000 base: $4,500, $3,000, $1,500.

Can I use this schedule for my tax return?

No — not directly. Tax systems prescribe their own asset lives, rates and conventions (MACRS in the US, capital allowances in the UK, and so on), which rarely match any book method. Use this for planning, pricing and understanding; use your tax authority’s tables, or an accountant, for filing.

📦 Embed this tool on your site

<iframe src="https://verystep.com/embed/depreciation-calculator/" title="Depreciation Calculator" width="100%" height="520" loading="lazy" style="border:0"></iframe>

Free to use. The embed shows a small "Powered by Verystep" link.

First time embedding? Read the step-by-step guide →

More free tools